Nerf N-Strike Elite Firestrike

Product Information

Thanks, I had never heard of that spring before, I'll have to give it a go, the prospects are intriguing. It is possible to push the Firestrike's range over 130ft with some good mods and ridiculous springs. On the end of the handle is a small hook-like piece of plastic, which extends down past the battery compartment. Singled Barrel: This barrel is front loading, and great for taggers, whistlers, holstering, and rounds that outlaw speedloaders. To enable personalised advertising (like interest-based ads), we may share your data with our marketing and advertising partners using cookies and other technologies.

Compact and Portable: The Nerf Elite Firestrike is compact and lightweight, making it easy to carry and maneuver during Nerf battles. This is my third firestrike i have modded like this, and I have never had any problems with them staying primed.It was re-released again with an orange, white, and gray color scheme; this re-release was shown off at the 2014 New York Toy Fair and was later released as the Elite XD variant. I no longer own this particular fire strike, as I put it in the COSTCOH raffle, or I would give it a try. This blaster had a soft release in December 2012 with an N-Strike standard color scheme of blue, white, and orange. Also, when you said the leads aren't marked, the longer lead is the positive one, if you hook that up wrong it will blow out the LED.

Wrap the plunger head in tape of your choice, I used plumber's teflon tape, but I have used electrical tape in the past, and it works fine. I use it mostly when I lend it out to friends who are confused by speedloaders, and always end up putting the darts into the wrong barrel. Tactical Rail: The blaster features a tactical rail on the top, allowing you to customize and accessorize your blaster with compatible Nerf attachments for added functionality. EDIT (3/7/14): I picked up a pair of non-freak Firestrikes, and so their performance will replace the freak Firestrike's performance. The seal on the Firestrike isn't perfect, so you can load the dart first or last and not affect performance.

Additionally, the trigger does not depress as much as most triggers I have pulled on other blasters. Drilling a pilot hole is recommended, but not necessary if you are very strong and have a sharp screw. First of you need to put a forceps that locks in to place right next to the LED, that will prevent damage to the light. The tight end of the barrels is tighter than the dart diameter, and so slowly squishes the rear end of the dart.

You can now place the LED back inside the black shroud and put the whole piece back inside the shell. Remove the AR backplate, and pound out the three support struts using a flathead screwdriver and mallet.It was given a soft release in December of 2012, along with the Strongarm and Stryfe in select retailers. Even in bright-light conditions, battlers are ready to take on the competition with this compact blaster.